Assembly Of The Riving Knife - Femi TS 36-523 8.45.00.25 Manuel D'instructions

WARNING: Before any adjustment, repair or maintenance work, and before changing the
blade, switch off the machine and disconnect it form any current source by removing the plug
from the socket.
1. Adjust the riving knife in order that there is a distance
from 2 to 5 mm between the blade and the riving knife
and check also the alignment between the riving knife
and the blade through a ruler.
2. Tighten the hexagonal screw. Then check again that
the blade is perfectly fixed and re-assemble the bench
inlay.
3. Then assemble the protective cap as illustrated in the
picture. Place it on the upper side of the riving knife in
order that the hole of the protective cap is perfectly
aligned with the one of the riving knife. Insert the
screw and tighten the stop nut.
DANGER: THE PROTECTIVE CAP MUST BE ALWAYS USED FOR ALL CUTTING
OPERATIONS TO AVOID ANY RISK OF CONTACT WITH THE BLADE.
IT RISES AUTOMATICALLY WHEN THE WORKPIECE PASSES THROUGH THE BLADE.
EN

ASSEMBLY OF THE RIVING KNIFE

38