Safety; Personnel Authorized To Use The Machine - Femi TS 36-523 8.45.00.25 Manuel D'instructions

WARNING:
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK AND INJURY WHEN USING
ELECTRICAL TOOLS, OPERATORS SHOULD ALWAYS OBSERVE BASIC SAFETY
PRECAUTIONS AS WELL AS THE THOSE INDICATED IN THIS MANUAL.
Read this instruction manual before using this product and keep it carefully.
Operations carried out using a power tool can become dangerous for the operator if safe and adequate operating
standards are not observed. As with any electrical machinery with moving parts, use of the tool entails certain risks.
If the tool is used as indicated in this manual, with due concentration on the work being performed, in observance
of safety regulations and wearing appropriate personal protective equipment, the risk of accidents and injury is
almost inexistent. Possible residual risks include:
1. direct or in direct contacts with electrical shock
2. injuries due to contact with moving parts
3. injuries due to contact with angular parts
4. injuries due to the ejection of tool parts or of the material you are processing
5. injuries due to noise
6. injuries due to inhalation of dangerous dust
7. injury caused by incorrectly installed tools
The safety equipment envisaged on tools, such as guards, casings, workpiece pusher, clamping devices and
personal protective equipment (such as goggles, dust masks, ear defenders, safety footwear and gloves) can help
reduce the risk of injury. However, not even the best safeguards can protect against a lack of common sense or
failure to operate with due care and attention. Always use your common sense and take all necessary precautions.
Only perform operations which you are sure are safe. DO NOT FORGET: everyone is responsible for his safety.
This tool has been designed for a specific use. FEMI urges you not to modify it or use it for any purpose other than
those for which it was specifically designed and built. In the event of any doubt concerning specific applications,
DO NOT use the tool until you have contacted FEMI and received the necessary clarification.
This machine has been designed and manufactured to be used by qualified personnel with adequate training,
experience and skills in accordance with the characteristics described below:
Operators / Trainees / Apprentices:
 may be male or female;

must be aged 14 or over,
 must have full use of both hands,

must have no physical or mental disabilities
 must know and fully understand the contents of the user manual.
READ AND KEEP THIS MANUAL

PERSONNEL AUTHORIZED TO USE THE MACHINE

EN

SAFETY

26