Oven Use; Aluminum Foil; Positioning Racks And Bakeware; Roll-Out Rack - Jenn-Air JMW2430 Guide D'utilisation Et D'entretien

Odors and smoke are normal when the oven is used the first few
times, or when it is heavily soiled.
During oven use, the heating elements will not remain on, but will
cycle on and off throughout oven operation.
IMPORTANT: The health of some birds is extremely sensitive to
the fumes given off. Exposure to the fumes may result in death to
certain birds. Always move birds to another closed and well-
ventilated room.

Aluminum Foil

IMPORTANT: To avoid permanent damage to the oven bottom
finish, do not line the oven bottom with any type of foil or liner.
For best cooking results, do not cover entire rack with foil
because air must be able to move freely.
To catch spills, place foil on rack below dish. Make sure foil is
at least ½" (1.3 cm) larger than the dish and that it is turned
up at the edges.

Positioning Racks and Bakeware

IMPORTANT: To avoid permanent damage to the porcelain
finish, do not place food or bakeware directly on the oven door or
bottom.
RACKS
Position racks before turning on the oven.
Do not position racks with bakeware on them.
Make sure racks are level.
Depending on the oven model, you could have flat, offset and/or
roll-out racks. If "f" is after the rack position, the flat rack should
be used. An "o" after the rack position indicates the offset rack
should be used. An "r" indicates the roll-out rack should be used.
For example: 1o, 3f, 5r indicates the use of the offset rack in rack
position 1, the flat rack in position 3, and the roll-out rack in
position 5. Refer to the section for the mode you are using for
specific rack recommendations.
27" (68.6 cm) Rack Positions
4
3
2
1
30" (76.2 cm) Rack Positions
5
4
3
2
1
BAKEWARE
To cook food evenly, hot air must be able to circulate. Allow
2" (5.0 cm) of space around bakeware and oven walls.
10

OVEN USE

The roll-out rack allows easy access to position and remove food
in the oven. The roll-out rack will fit in all positions.
Open Position
Closed and Engaged Position
To Insert Roll-Out Rack
1. Angle the rack assembly up and insert the back edge into the
"V" cutout in the rack guides of the oven cavity.
2. Keep the rack lifted at an angle and push in until the back
edge of the sliding rails (A) bypass the lower "V" cutout.
3. Angle the rack downward and continue to gently slide the
assembly in until the center brace (C) bypasses the "V"
cutout.
4. Raise rack assembly to flat position and gently push to the
back of the oven until the back edge of the sliding rail drops.
5. Pull the rack assembly slightly forward until the front edge
drops and the sliding rails are on the rack guide.

Roll-Out Rack

A. Slide rails
B. Sliding shelf
C. Center brace
A
A. "V" cutout
B. Rack guide
C
B
A
B