Hitachi B16RM Mode D'emploi page 13

ASSEMBLY AND ADJUSTMENTS
ESTIMATED ASSEMBLY TIMES 20~40 MINUTES
ASSEMBLY INSTRUCTIONS
WARNING
For your own safety, never connect plug to power
source outlet until all assembly and adjustment steps
are completed, and you have read and understood the
safety and operating instructions.
WARNING
The Drill Press is very heavy and MUST be assembled
with the help of 2 PEOPLE OR MORE, to safely
assembly it.
COLUMN SUPPORT TO BASE (FIG. A)
1. Position the base (1) on the floor.
2. Place the column (2) on the base, aligning the holes
in the column support with the holes in the base.
3. Locate the four long hex bolts (3) from the loose
parts bag.
4. Place a bolt in each hole through the column support
and the base. Tighten with an adjustable wrench.
Fig. A
3
INSTALLING THE TABLE (FIG. B and C)
1. Locate the table crank (1) and support lock (2) from
the loose parts bag.
2. Insert the support lock handle from the left to right
into the hole (3) at the rear of the table support
assembly. Tighten by hand.
3. Install the table crank handle (1) onto the small shaft
(4), aligning the set screw (5) with the flat surface of
the shaft (4). Tighten the set screw with a hex
wrench.
4. Loosen the support lock (2). Raise the table
5. Place the table (6) in the table arm assembly. Tighten
2
INSTALLING BATTERY FOR LASER GUIDE (FIG. C-1)
1. Open the cover of battery box.
1
2. Install 2 pieces of 1.5V 3A batteries into the battery
3. Close the cover.
4. Turn on the switch to check the LASER GUIDE.
NOTE: Replace the batteries with batteries that have
a rating of 1.5 volts (Number 4 series and AAA size
or equivalent). When replacing the batteries, the
battery guide should be thoroughly cleaned. Use a soft
paintbrush or similar device, to remove all sawdust and
debris.
– 13 –
Fig. B
arm assembly by turning the crank handle (1)
clockwise. Tighten the support lock. (Fig. C)
the table lock handle (7). (Fig. C)
6
Fig. C
7
box.
Fig. C-1
English
2
3
4
5
1
2
1