Product Specifications - Hitachi B16RM Mode D'emploi

Some dust created by power sanding, sawing, grinding, drilling and other construction activities contains
chemicals (known to the State of California) to cause cancer, birth defects or other reproductive harm. Some
examples of these chemicals are:
• Lead based paints
• Crystalline silica from bricks, cement and other masonry products
• Arsenic and chromium from chemically treated lumber
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your
exposure to these chemicals, work in a well-ventilated area and work with approved safety equipment, such as
dust masks that are specially designed to filter out microscopic particles.
PRODUCT SPECIFICATIONS
Swing ....................................... 15" (380mm)
Chuck Size................................ 5/8" (16mm)
No Load Speed......................... 12 Speeds
Voltage ..................................... 230V / 50Hz
Watts ........................................ 750W
Amps ........................................ 3.6A
Built-in Light.............................. 60 Watt (Maximum)
........................................... Alternating current
The noise levels of this machine during operating are as follows:
sound pressure level under no load: 71.3 dB
sound pressure level under load: 78.5 dB
sound power level under no load: 84.3 dB
sound power level under load: 91.5 dB
To avoid electrical hazards, fire hazards or damage to the drill press, use proper circuit protection.
This drill press is wired at the factory for 230 Volt operation. It must be connected to a 230 Volt / 3.6 Ampere
time delay fuse or circuit breaker. To avoid shock or fire, replace power cord immediately if it is worn, cut or
damaged in any way.
Before using your drill press, it is critical that you read and understand these safety rules. Failure to follow
these rules could result in serious injury to you or damage to the drill press.
Wear safety goggles
Wear ear protection
Wear a breathing mask
WARNING
210-2,580min
-1
(Bulb not included)
WARNING
– 5 –
Table Size ................................. 13- 15/64" x 13-15/64"
Table Tilt .................................... 45° Right or Left
Spindle Travel............................ 3-11/32" (85mm)
Throat......................................... 7-1/2" (190.5mm)
Base Size .................................. 11" x 20-3/8"
Height......................................... 63-11/16" (1,617.5mm)
Net Weight... .............................. 165 lbs (75kg)
ENVIRONMENTAL PROTECTION
Recycle unwanted materials instead of
disposing of them as waste. All tools,
hoses and packaging should be sorted,
taken to the local recycling center and
disposed of in an environmentally safe
way.
English
(336mm x 336mm)
(279mm x 518mm)