Hitachi B16RM Mode D'emploi page 17

THE LASER GUIDE
Your tool is equipped with our latest innovation, the
Laser Guide , a battery powered device using Class II
laser beams. The laser beams will enable you to preview
the drill bit path on the workpiece to be drilled before you
begin your operation.
WARNING
AVOID DIRECT EYE CONTACT
A Laser light is radiated when the laser guide is turned
on. Avoid direct eye contact. Always turn off the laser
and unplug the drill press from the power source before
making any adjustments.
•
A laser pointer is not a toy and should not come into
hands of children. Misuse of this appliance can lead
to irreparable eye injuries.
• Any adjustment to increase the laser power is
forbidden.
• When using the laser pointer, do not point the laser
beam towards people and /or reflecting surfaces.
Even a laser beam of lower intensity may cause eye
damage. Therefore, do not look directly into the laser
beam.
• If the laser pointer is stored for more than three
months without use, please remove the batteries to
avoid damage from possibly leaking batteries.
•
The laser pointer includes no servicing components.
Never open the housing for repair or adjustments.
• On units equipped with the Laser-Guide attachment,
repairs shall only be carried out by the laser
manufacturer or an authorized agent.
• Laser Warning label: Max output <1mW DIODE
LASER:630-670nm, Complies with 21CFR 1040.10
and 1040. 11.
ADJUSTING THE LASER LINES (FIG. O)
A. How to check the Laser-beam Alignment?
1. Adjust the table height so it is 7 inches below the
bottom of the chuck
BASIC DRILL PRESS OPERATIONS
SPEEDS AND BELT PLACEMENT (FIG. P)
This drill press has 12 speeds, as listed below:
210 min -1 500 min -1
280 min 540 min
-1 -1
320 min -1 830 min -1
420 min -1 1290 min -1
See the inside of the pulley guard for same chart as
shown in figure P.
OPERATIONS
1350 min -1
1580 min
-1
2180 min -1
2580 min -1
-1
210min 280min -1 320min
830min -1 1 290min -1 1 350min
2. Scribe a round circle (approx. 1/8 inch) on a piece of
scrap wood.
3. Insert a drill bit into the chuck and tighten.
4. Lower the quill and align the scribed circle with the
drill bit & fasten the wood to the table.
5. Turn on the laser and verify the laser lines (x) are
centered onto the scribed circle.
B. ALIGNING THE LASER-BEAM (FIG. O)
To adjust the laser lines:
NOTE: Lower the chuck quill and lock it in place by
spinning the lower depth stop nut.
1. Lower the drill press quill One inch and lock into
place by spinning the depth stop (see Fig. V).
2. Turn the screw (1) until the laser beam is at it's
desired setting.(both screws)
3. If the laser guide is not centered on the scribe then
contact your Authorized Service Center for bolt (2)
adjustments.
Laser is radiated when laser guide is turned on. Avoid
direct eye exposure. Always un-plug drill pres from
power source before making any adjustment.
LASER ON/OFF SWITCH (FIG. O)
To turn the laser On or Off, press the rocker switch (3).
Fig. O
3
To avoid possible injury, keep the guard closed, in place,
and in proper working order while the tool is in operation.
Fig. P SPEED CHART
-1 -1
-1 420min 500min
-1 1 580min -1 2 180min -1
– 17 –
WARNING
1
2
WARNING
540min -1
2 580min -1
English