HSM Shredstar X8pro Notice D'utilisation page 9

6 Troubleshooting
LED-indicator
No LED lights up
Both LEDs light up
The red LED fl ashes Overheating
Only the red LED
lights up
For any other malfunctions, switch off the machine and get in touch with our customer service.
Instructions on removing the CD container
3
2
1
Push down the front of the container (1), push it
back (2) and lift the container out of the bracket
(3).
Note that the shredder can only be switched on
when the CD container is properly in place.
02/2011
Cause Remedy
- Place the cutting head correctly on the base cabinet
and push the containers for shredded paper and CDs in
properly.
Press "I" on the
The shredded Empty the container.
paper container If you take the cutting head off the base cabinet, take
is full care not to damage the fl ap on the bottom of the cutting
head.
The maximum uninterrupted operating time is fi ve
minutes. Let the machine cool down for around
20 minutes.
Paper cutting Press "R" on the switch.
unit overloaded Note: The cutting unit starts up with a delay of two
seconds.
Remove the paper.
Do not feed in more than 8 sheets of paper at a time.
switch.
7 Cleaning and maintenance
Switch off the shredder and pull out the mains
plug. When cleaning only use a soft cloth and
a mild soap-water solution. However, no water
may enter the equipment.
Oil the cutting unit when
cutting performance deterio-
rates or the device becomes
noisy, or every time you
empty the waste container.
• Squirt special cutting unit oil (order number
1.235.997.403) through the paper feed
across the entire width of the cutting shafts.
• Without feeding in paper, run the cutting unit
in reverse (R).
This loosens paper dust and particles.
9