HSM Shredstar X8pro Notice D'utilisation page 8

3 Machine components
1 2 3 4 5 6
1 Shredded paper container
2 Cutting head
3 Feed opening for CDs
4 Feed opening for paper and cards
5 Safety notice
6 Container for shredded CD
7 LED indicator
8 Rocker switch
I: On
O: Off
R: Reverse
9 Base cabinet
4 Setting up
Take the shredded paper container and
cutting head out of the base cabinet.
• Carefully place the cutting head on the base
cabinet.
The lugs on the bottom of the cutting head
latch into the openings on the base cabinet.
• Push the shredded paper container into the
base cabinet until it latches in the housing.
• Plug in the mains plug.
8
7 8 9
5 Operation
Switching the paper shredder on
• Press the rocker switch „I".
The rocker switch locks in place.
The green LED lights up.
The paper shredder is ready for
operation (standby).
Shredding paper and credit cards
• Feed in only one credit card
or no more than 8 sheets of
paper.
The light barrier starts the
cutting unit automatically.
The material is pulled into the
cutting unit and shredded.
Three seconds after the
feed opening is clear again,
the shredder switches off
automatically and goes into
standby.
Shredding CDs
The CD is cut into fi ve strips.
The shredder switches off.
Switching the paper shredder off
• Press the rocker switch "R".
The rocker switch locks in place.
The machine is equipped
with a separate CD
cutting unit. Push the CD
into the feed opening
until the cutting unit
catches it.
02/2011