Steba IK 100 Mode D'emploi page 12

Power
Press the „Stufe" button, the light turns on.
The Power is displayed in Watt.
With the buttons „+/-" the power can be adjusted in 10 steps.
Left plate 400-1800Watt
Right plate 400-1300Watt
The Power function is suitable to boil water, soups etc.
If meat or vegetable is broiled, the temperature function should be used, to avoid
any overheating.
The appliance is equipped with an overheat protection. If the pots gets to hot the
appliance switches off, a buzzer sounds and at the display „E2" is shown. If this case
happens, the „On/Off „ button should be pressed and the appliance cooled down for
some minutes. After that the appliance works again normally.
Temperature:
Press the „Temp" button, the light turns on.
With the buttons „+/-" the temperature can be adjusted in 20 degree steps. The build
in temperature sensor keeps the adjusted temperature (60°C-240°C).
Timer:
Either Temperature or Power was adjusted. Press the button „Timer, the light turns
on at „Temperature" or „Stufe" and at „Zeit". The Display shows „0". The time can be
adjusted by pressing „+/-" in 5min steps (max. 180min).
During the usage of the appliance the time can be adjusted in 5 min steps by pressing
the „+/-" buttons. The time added or subtracted from the adjusted time.
Shall the power or the temperature be changed, press the „Stufe" or
„Temp" button. The adjusted steps can be seen on the display and changed by pres-
sing the „+/-" button.
After the time runs out, the appliance switches off.
Safety switch off:
Was the time not adjusted and the appliance is used in the „Power" or „Tempera-
ture" function, the appliance will switch off automatically 120 min after the last
button was pressed.
Guarantee
The guarantee conditions for this appliance are as defined in our „Instructions for
use" in German.
12