Shooting - Panasonic AW-HE100E Mode D'emploi

Shooting

When performing the operations using the
accessory wireless remote control
 Changing the camera's direction
Moving the camera toward the left or right (panning):
Press the [] or [] button.
Moving the camera up or down (tilting):
Press the [] or [] button.
Moving the camera diagonally:
Press the [] or [] button and [] or [] button at
the same time.
Returning the camera to the reference position:
Press the [HOME] button for two seconds.
 Using the zoom function
Zooming in (the subject becomes magnified in size):
Use the [T] button of [ZOOM].
Zooming out (the subject becomes reduced in size):
Use the [W] button of [ZOOM].
 Switching the direction or zoom speed
Changing the direction or zoom at high speed:
Press the [FAST] button.
Changing the direction or zoom at low speed:
Press the [SLOW] button.
The lens focus control speed is also changed at the same
time.
When performing the operations
using the controller
 Changing the camera's direction
Moving the camera toward the left or right (panning):
Tilt the [PAN/TILT] lever toward L or R.
Moving the camera up or down (tilting):
Tilt the [PAN/TILT] lever toward UP or DOWN.
Moving the camera diagonally:
Tilt the [PAN/TILT] lever diagonally.
Returning the camera to the reference position:
If the controller has a [HOME] button, press the
[HOME] button.
 Using the zoom function
Zooming in (the subject becomes magnified in size):
Tilt the [ZOOM] lever toward the TELE direction.
Zooming out (the subject becomes reduced in size):
Tilt the [ZOOM] lever toward the WIDE direction.
 Changing the direction or zoom speed
AW-RP655 and AW-RP555:
Press the [SPEED] button.
Each time the [SPEED] button is pressed, the control
speed is switched between the high speed (the button's
lamp is off) and low speed (the button's lamp is lit).
The lens focus control speed is also changed at the
same time.
AW-RP400:
Turn the [PAN], [TILT], [ZOOM] dial of
[SPEED CONTROL].
Turning the dial counterclockwise as far as it will go can
disable all operations.
For further details, refer to the Operating Instructions of the
controller.
21 (E)