Cleaning - Steinbach Poolrunner Battery Basic Notice Originale

Lifting the device out of the pool
The pump of the device can be damaged if it is switched on or off
outside of the water.
- Only switch the device on or off when it is located below the
water surface.
1. Slowly pull the device to the surface by the floating handle
until you can reach the handle
until it snaps into place.
If the floating handle is out of reach, use the supplied hook
extensible rod (not part of the package contents).
The device is switched off.
2. Slowly lift the device out of the water by the handle and hold it above the water
surface for 10 to 15 seconds so that most of the water can flow back into the pool.
3. Set down the device next to the pool.
The device is lifted out of the pool.
Clean the device after each use to ensure continued fault-free operation.

Cleaning

Improper cleaning might damage the device.
- Clean the surface of the device with plain tap water after each
use.
- Do not use any aggressive cleaning agents.
- Do not use any sharp or metal objects such as knives, hard
scrapers or similar.
- Do not use any cleaning brushes.
- Do not use a high-pressure cleaner.
40
NOTICE!
and press the ON/OFF
8
NOTICE!
and the nylon cord
5
switch on the bottom
13
together with an
6