Belkin OmniView SMB CAT5 F1DP104Aea Manuel De L'utilisateur page 25

Installation
Step 4
Connect the SMB CAT5 KVM Switch to the Server Interface Module using
the included Belkin CAT5e Patch Cable or other CAT5 cable. (Refer to
diagram below.)
Step 5
Power-up your server.
Step 6
Repeat Steps 1 through 4 for each additional Sun server you wish
to connect.
NOTE: When a USB or Sun Server Interface Module is connected to a Sun
server, the Server Interface Module emulates the Sun keys using a set of key
combinations called Combo Keys. Refer to the table on page 39 for a list of
Sun functions supported by the SMB CAT5 KVM Switch.
22 22