Brandt TV399XF1 Guide D'utilisation Et D'installation page 5

P
ositioning
C
onnection
Your hob (220-240 V∼ 50 Hz, 6,9 kW) must be
connected to the mains with :
- A H05RRF type cable with three 2.5 mm² conduc-
tors or five 1.5 mm² conductors (including a yellow
/ green earth wire).
400 V
220-240 V
1
L1
2
3
N
4
32 amp
16 amp
Your hood (220-240V∼ 50 Hz-240 W) eis supplied
with an H05 VVF cable with 3 0.75mm wires
(negative, positive and earth).
10 or 16 amp fuse
Installing your duo in complete safety
- You must not exceed the maximum number of bends or
the maximum length of the duct.
- Centred hob and hood
- First of all install your hood to avoid any risk of damage to
your hob. Check the position of the electric junction box.
Try to hide this in the body of the hood.
50
4,1
These duo must be connected to the mains using
a plug in compliance with the publication CEI
60083 or an omnipolar circuit braking device at
least 3mm from the contact opening.
When the power is switched on, or after a long
power failure, a light code appears on the
control panel. This disappears automatically
after about 30 seconds or as soon as any touch
control is touched on the panel. This is normal,
as the display is for use by the after-sales
service when required The user must not take
L1
1
this into account under any circumstances.If
the unit has a 3 phase 400 V2N connection,
2
L2
and is not working correctly, check that the
neutral wire is correctly connec-ted. This
3
N
precaution should also be taken for all your
4 other electronic apparatus.
The unit must be installed so that the
mains plug is easily accessible.
When installing the cooktop, great care should
be taken to prevent sharp edges from damaging
the power cable.
5
58
48,8
55,5
dimensions in cm
51