Polygroup SUMMER WAVES ST1100 Manuel Du Propriétaire page 32

IMPORTANT SAFETY INFORMATION
1. Make sure all the Hoses
13 14
2. Always press down the 6-port Valve Handle
3. Always turn off the pump power when switching position.
4. It is critical to the backwash the sand before using the pump to clean the pool water. This will
prevent fine sand to flow into the pool and also wash off any dirt or debris within the sand.
7. Fill the pool until the water level reaches the pool fill line.
8. Follow the following steps to BACKWASH the sand before first use:
• Remove the 6-Port Valve Drain Outlet Cap
1.5" [38mm] hose can be connected to the drain port to direct the waste water to a nearby drain.)
• Press down the 6-Port Valve Handle
• Turn on the power of the Pump
• Pool water is now circulating backward through the sand bed
to the drain outlet. Continue BACKWASH until the drain water
becomes clean and clear.
• Turn off the Pump and switch the handle to the "RINSE" position.
17
Turn on the Pump for ONE minute, this will clean up and
17
level out the sand bed. Turn off the Pump
9. To start filtering the pool, turn the 6-Port Valve Handle
position and then switch on the Pump
ready from the Pressure Gauge
when the sand bed is clean.
10. BACKWASH the tank when the pressure is 1-1.5 bar (14.5 - 21.8 Psi) above the
initial pressure. Or, BACKWASH the sand filter once every TWO weeks to
maintain water cleaniness.
14
are secured to the fittings on the pump and pool.
before switching position.
19
from the 6-Port Valve
11
and turn to the "BACKWASH" position.
19
.
17
when done.
17
to the "FILTER"
19
. Record down the sand tank pressure
17
. This reading indicates the initial tank pressure
12
. (Optionally, a
10
Port d'entrée
19
ENTRÉE DE POMPE
19
Port de sortie
11