Erreka NET Manuel De L'installateur page 66

STARTING UP AND PROGRAMMING
Advanced Functions Programming (D1= "A")
1 Press ENTER to access the programming menus. The
display lights up and D1 flashes.
2 Press the buttons ^ and
A flashing. Press ENTER to confirm. D2 flashes.
D1 D2 Parameter
A 0 Flashing light
1 Garage light time
2
Barrier speed
3
Slowdown speed
4 Slowdown distance
5
6
Maximum thrust
Closing photocell used during
7
standby (in automatic mode
only)
Pushbutton operation during
8
standby (in automatic mode
only)
9
Opening mode
62
Installation Manual
until D1 shows the letter
V
D3 D4
0 1
0 2
0...5. 0...9
0 1...5
0 1...5
0 0...5
0...1 0...9
0 1
0 2
0 3
0 1
0 2
0 3
0 1
0 2
0 3
3 Press the buttons ^ and
parameter appears. Press ENTER to confirm. D3 and
D4 flash.
4 Press the buttons ^ and
D4 value appears (see chart). Press ENTER to
confirm.
5 Press ESC to return to the previous display.
P r e -
determined Options or values
option
x No pre-warning
With pre-warning
03 03
= 3 secs;
2.5
= 2 min. 50 secs, etc
03 01
: minimum speed;
02 01
: minimum speed;
00 00
: minimum distance;
distance
Disabled
05 01
: minimum thrust;
Immediate close
x Restart standby time
Has no effect
Immediate close
x Restart standby time
Has no effect
x Opening in accordance with the mode
selected in the main functions (F)
Collective opening
(the control board does not obey t he
commands during opening)
Step-by-step opening
(the barrier halts if a key command is activated
during opening. The barrier closes if activated
again)
until the required D2
V
until the required D3 and
V
59
= 59 secs;
05
: maximum speed
05
: maximum speed
05
: maximum
10
: maximum thrust