Programming Sequence - Erreka NET Manuel De L'installateur

STARTING UP AND PROGRAMMING
3

PROGRAMMING SEQUENCE

Display
?
ENTER
á
or
à
CL

Before entering the programming menus, it is
necessary to close the barrier or disconnect the
device and then reconnect.

Press the ENTER button to access the programming
menus.
The display shows "C"1 01 or "C"1 0 2.

Use the keys ^ and
and confirm by pressing ENTER.

Use ESC to go back to the previous display.

To leave the programming menu, press ESC several
times until the display goes off or shows CL.
Prior Conditions Programming (D1= "C")
1 Press ENTER to access the programming menus. The
display lights up and D1 flashes.
2 Press the buttons ^ and
C flashing. Press ENTER to confirm. D2 flashes.
3 Press the buttons ^ and
parameter appears. Press ENTER to confirm. D3 and
D4 flash.
D1 D2 Parameter
C 1 Motor turning direction
4
5
Closing safety device (photocell
or strip)
60
Installation Manual
General navigation through the programming parameters and menus
D1
C
ESC
Select the value
using ^ and
V
to select the required values,
V
until D1 shows the letter
V
until the required D2
V
D3
0
0
0
1
1
D2
ENTER
á
1
ESC
à
Select the value
using ^ and
V
1 Programme the prior conditions (see "Prior
Conditions Programming (D1= "C")" on page 60).
2 Programme the radio codes, along with the barrier
open/close (see "Radio Code Programming (only
with RSD) and barrier open/close (D1= "P")" on
page 61).
3 Programme
automatic standby time (see "Main Functions
Programming (D1= "F")" on page 61).
4 Programme the advanced functions (see "Advanced
Functions Programming (D1= "A")" on page 62).
4 Press the buttons ^ and
D4 value appears (see chart). Press ENTER to
confirm. The display shows
5 Whilst the display shows
operated using the ^ and
direction.
6 Press ESC to return to the previous display.
Pre-determined
D4
option
1 x
2
0
x
0
1
D3 - D4
ENTER
á
0 X
ENTER
(confirming)
à
Select the value using
^ and
ESC
(unconfirmed)
à
the functioning mode
until the required D3 and
V
.
, the barrier can be
buttons to check turning
V
Options
Disabled
Device not installed
Device without testing
Device with testing
V
and the