Main Parts; Functioning Modes - Erreka NET Manuel De L'installateur

DESCRIPTION OF THE PRODUCT
3

MAIN PARTS

4

FUNCTIONING MODES

Automatic mode (F101)
Opening: this begins by activating the key command
(transmitter, magnetic key, key switch, etc).
• Collective opening: during opening, the control
board does
(configurable in the advanced options menu, see
"Advanced Functions Programming (D1= "A")" on
page 62).
Step-by-step mode (F102)
Opening: this begins by activating the key command
(transmitter, magnetic key, key switch, etc).
• Step-by-step opening: the barrier halts if the key
command is
(programmable in the advanced options menu, see
"Advanced Functions Programming (D1= "A")" on
page 62).

The display shows pause situation
The barrier closes when the key command is activated
again.
50
Installation Manual
not obey the key commands
activated during
PA
.
1
Motoreducer with encoder
2
Balancing spring
3
Balance spring tensioner
4
Built-in control panel
5
Unlocking knob for manual operation
6
Adjustable stoppers for opening and
closing
7
Arm
Standby: the barrier remains open during the
programmed time.
• If the key command or the photocells are activated
during standby, standby time restarts (configurable
in the advanced options menu, see "Advanced
Functions Programming (D1= "A")" on page 62.
Closing: the closing operation starts automatically
once standby time is finished.

If, during closing, the key command is activated, the
barrier inverts operation direction and opens
completely.
Standby: the barrier remains open indefinitely until the
key command is activated.
Closing: the closing process starts up by using the key
opening
command.

If, during closing, the key command is activated, the
operator inverts the movement and opens the
barrier.