Rittal CMC III Notice D'installation Et Notice D'utilisation Succincte page 9

5.3 Settings
By default, all included MIFARE transponder cards (13.56 MHz) have access authorisation for the han-
dle installed on the CMC III CAN bus access. The access authorisation is changed in the access.cmc3
file. After the first access attempt, this file is contained in the upload folder on the CMC III Processing
Unit. It can be downloaded with FTP and then changed with an editor.
Further information concerning this topic is contained in the main guide at www.rittal.com (see
Section 1.1).
In a later update, it is planned to integrate the configuration of the access authorisations on the Web
user interface.
• Hold an authorised transponder card in front of the transponder reader unit.
The green LED lights continually for approx. 2 seconds (Fig. 2, Pos. 3).
• Hold an unauthorised transponder card in front of the transponder reader unit.
The red LED lights continually for approx. 2 seconds (Fig. 2, Pos. 2).
To determine whether any software updates are required: see www.rittal.com or contact Rittal Service
(see Section 6).
6 Service
For technical questions, please contact:
Tel.: +49 (0) 2772/505-9052
E-mail: info@rittal.de
Homepage: www.rittal.com
For complaints or service requests, please contact:
Tel.: +49 (0) 2772/505-1855
E-mail: service@rittal.de
Rittal CMC III Transponder Reader
Service
EN
8