Zanussi ZBB3294 Mode D'emploi page 11

x
x
If necessary cut the adhe-
sive sealing strip and then
apply it to the appliance as
shown in figure.
Remove the correct part
from the hinge cover (E).
Make sure to remove the
part DX, in the case of right
hinge, SX in opposite case.
2
1
Install the appliance in the
niche.
Push the appliance in the
direction of the arrows (1)
until the upper gap cover
stops against the kitchen
furniture.
Push the appliance in the
direction of the arrows (2)
against the cupboard on the
opposite side of the hinge.
C
D
E
E
B
Attach the covers (C, D) to
the lugs and the hinge
holes.
Install the vent grille (B).
Attach the hinge covers (E)
to the hinge.
4mm
44mm
Adjust the appliance in the
niche.
Make sure that the distance
between the appliance and
the cupboard front-edge is
44 mm.
The lower hinge cover (in
the accessories bag) makes
sure that the distance be-
tween the appliance and the
kitchen furniture is correct.
Make sure that the clear-
ance between the appliance
and the cupboard is 4 mm.
Open the door. Put the low-
er hinge cover in position.
G
H
Connect the appliance later-
ally to the kitchen furniture
sidewall:
1. Loosen the screws of
the part (G) and move
the part (G) till the fur-
niture sidewall.
2. Tighten the screws of
the part (G) again.
3. Attach the part (H) to
the part (G).
I
I
Attach the appliance to the
niche with 4 screws.
Ha Hb
Hc
Hd
Disconnect the parts (Ha),
(Hb), (Hc) and (Hd).
11