Connecting Of Ac Adapter And Video Cable - Elmo TT-02 Mode D'emploi

Connecting of AC adapter and Video cable

(4) DC IN 12V terminal
• To power plug
(1) RGB OUT terminal
• To projector
(2) RGB IN terminal
• To PC monitor
(1) Connecting to the unit with analog RGB input terminal equipped
Connect the supplied analog RGB cable to the [RGB OUT] terminal on the rear panel.
• The display position may be displaced from the center of the screen. In such case, adjust
the horizontal and vertical positions manually from the connected device.
• Vertical strips may appear on the projector or PC monitor screen. This can be mitigated
by manually adjusting the dot clock from the connected device.
(2) Connecting to the unit with analog RGB output terminal equipped
Connect the supplied analog RGB cable to the [RGB IN] terminal on the rear panel.
Note
• When using a notebook PC with an external output mode switching, set the notebook
PC side to the external output mode after pushing the manual operation button [PC] of
this equipment.
Specifications of the analog RGB input terminal of this product
Signal allocation
5 4 3 2 1
10 9 8 7 6
15 14 13 12 11
DSUB 15P shrink terminal (Female)
Pin assignment
Pin No. Name
1 Video signal (Red)
2 Video signal (Green)
3 Video signal (Blue)
4 N.C
5 GND
(3) VIDEO OUT terminal
• To PC
• To TV monitor
Video signal :
Horizontal synchronized signal :
Vertical synchronized signal :
Pin No. Name
6 GND (Red)
7 GND (Green)
8 GND (Blue)
9 N.C
10 GND
English
Analog 0.7V(p-p) 75W terminated
TTL level (Positive/negative polarity)
TTL level (Positive/negative polarity)
Pin No. Name
11 GND
12 N.C
13 Horizontal
synchronized signal
14 Vertical
synchronized signal
15 N.C
P1~P32
15