M.adjustable Locking Flip-Up Armrests; N.footrest System - Zippie X'CAPE Mode D'emploi

Z I PP IE X' CA PE
M. ADJUSTABLE LOCKING FLIP-UP ARMRESTS
1. Height Adjustment
a. Loosen bolt and nut (A) and remove flip-back tube (H).
b. Loosen bolts (B, C) and remove clamp (D).
c. Move the clamp (D) up or down to the desired position.
d. Tighten bolts (B, C).
e. Install the flip-back tube (H) back in place and tighten hardware (A).
f. Repeat the process for the other armrest.
2. Angle-Adjustment
a. Loosen screw (E).
b. Set armrest at desired angle using preset holes in armrest angle plate.
c. Tighten screw (E) to 120 in-lbs.
3. Length-Adjustment (optional)
a. Remove foam grip or armpad (G) from armrest.
b. Loosen the nut and screw (F) in the adjustable flip-up tube.
c. Reposition the armpad at the desired length.
d. Re-tighten the screw and nut (F).
e. Re-attach foam grip or armpad back in place.
N. FOOTREST SYSTEM
The footrest position is key to keeping the body in the proper alignment, and providing a stable support for
your legs and torso. Make sure that your Sunrise dealer has correctly adjusted your footrests and/or legrests
with the advice of a healthcare professional. The original setup should not be changed without first checking
with that advisor. Legrests and footrests should be swung out of the way, or removed for transfers. .
NOTE – Footplate must have at least 2inches of clearance between the footplate and the ground to prevent
hitting obstacles and risking a fall or tip-over.
1. Footrest/Footplate positioning using the rotational clamp
a. Loosen the two rotational/Angle clamp screws ( J )
b. Rotate the footrest/ footplate until the desired position and angle is achieved.
c. Tighten the Clamp hardware to proper torque (DO NOT EXCEED a 120 in-lb Max torque).
2. Footrest positioning using footplate spacers
a. Remove footplate spacers (Show)
b. Slide footplate to desired depth position.
c. Replace footplate spacers
3. Height range adjustment (Direct Mount Footrest)
a. Adjust the footplate mounting position by removing the button head screw from the adjustment hole
(L) and moving the assembly to the desired position.
b. Tighten hardware to proper torque (120 in-lb Max)
4. Height range adjustment (Extension Mount Footrest)
a. Loosen set screw (M)
b. Slide footrest extension tube up or down inside frame tube to desired height..
c. Tighten set screw to proper torque (120 in-lb)
MK-100090 RevA
45
49
46 47 48
IX. DEALER SERVICE AND ADJUSTMENT
24
E
G
F
J
45
H
46
47
48
49