Armrest Receiver Attachment; T-Post Armrest; Flip-Up Armrests - Zippie X'CAPE Mode D'emploi

Z I PP IE X' CA PE
J. ARMREST RECEIVER ATTACHMENT
Mounting
1. Thread the two screws and washers (A) thru the rear side frame tube, and into the single post height-
adjustable armrest receiver (B).
2. Tighten the hardware to 120 in-lbs.
Adjustment
1. To adjust the fit of the Single Post Armrest in the receiver, loosen the 4 hex bolts (C) by using a 7/16"
wrench .
2. With the armrest assembly in the receiver (B), press firmly on the outside of the receiver.
3. Maintain pressure on the receiver and re-tighten two of the hex bolts (C).
4. Remove the armrest assembly and re-tighten the remaining two hex bolts.
5. The armrest should fit firmly into the receiver and lessen any noise that may result from vibration.
NOTE– Armrest Receiver may share hardware with wheel lock assembly if required.
43
K. T-POST ARMREST
1. Lateral Adjustment
a. Remove the receiver bolts (D).
b. Move the Receiver (E) forward or back to the desired position.
c. Tighten the hardare to 120 in-lbs
2. Height Adjustment
a. Remove the screws for the Kids Arm Stop (F).
b. Using one of the three preset holes in armrest post, adjust to the preferred height. (E).
c. Replace and tighten hardware. to 120 in-lbs
.
NOTE– Armrest Receiver may share hardware with wheel lock assembly if required.
L. FLIP-UP ARMRESTS
1. Adjustment
a. Loosen clamp bolts (G).
b. Move clamp up or down backrest posts to desired position.
c. Tighten bolts to 120 in-lbs
2. Angle-Adjustment
a. Loosen bolt (I).
b. Set armrest at desired angle using preset holes in armrest angle plate (H).
c. Tighten bolt to 120 in-lbs
41 42
44
IX. DEALER SERVICE AND ADJUSTMENT
23
41
42
44
MK-100090 RevA