Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Z I PP IE X' CA PE
F. TO MOUNT & REMOVE REAR WHEELS
Do not use this chair UNLESS you are sure both quick-release axles are locked. An unlocked axle may come
off during use and cause a fall.
1. To Install Wheel
a. Depress quick-release button (A) fully. This will release tension on ball bearings at other end.
b. Insert axle (B) through hub of rear wheel.
c. Keep button (A) depressed as you slide axle (B) into axle sleeve (C).
d. Release button to lock axle in axle sleeve. Adjust axle if it does not lock. See Section B.
e. Repeat steps on other side.
NOTE–
The axle is not locked until the quick-release button pops out fully (A). Check that the axle is
locked by pulling on the wheel in the direction of the axle.
2. To Remove Wheel
a. Depress quick-release button (A) fully.
b. Remove wheel by sliding axle (B) completely out of axle sleeve (C).
c. Repeat steps on other side.
G. WHEEL LOCKS
Wheel locks are installed at Sunrise and should be adjusted by your qualified service person.
Inspect wheel locks weekly per the maintenance chart. Do not use your chair UNLESS you are sure both
wheel-locks can fully engage. A wheel-lock that is not correctly adjusted may allow your chair to roll, or turn
unexpectedly.
Wheel-locks must be adjusted after making sure the tires have the correct air pressure. When fully engaged,
the arm should be imbedded into the tire at least 1/8" to be effective.
If you find the wheel locks have slipped or are not working correctly contact your service provider for prop-
er adjustment.
H. HUB LOCKS
15
16
To operate Hub Lock
1. To Lock rear wheels, press button (D). Lever (E) will flip outward.
2. To unlock wheels, press Lever (E) back down until Button (D) pops back out. Each lever operates one
side of the chair. To fully lock chair, both buttons must be pushed.
NOTE–
Do not engage hub lock when chair is in motion.
To adjust the cables
1. Loosen jam nut (F) using a 10mm wrench.
2. Turn adjustment screw (G) in our out as necessary. Turning screw upward will loosen cable, turning
downward will tighten cable.
3. Re-tighten jam nut (F) against lever mount.
4. Repeat steps 1-3 for opposite side of chair as necessary.
To adjust lever position
1. Remove socket screw (H) and washer (I) from lever and backrest.
2. Choose desired hole in backrest to mount lever and re-install screw and washer.
3. Repeat steps 1-2 for opposite side of chair.
12
13
WARNING
WARNING
WARNING
15
VIII. USE AND MAINTENANCE
A
H
F
I
G
12
13
14
15
16
MK-100090 RevA
Publicité
Chapitres
Table des Matières
