Footrest System; Swing-Away Footrest; M.upholstered Backrest - Zippie X'CAPE Mode D'emploi

Z I PP IE X' CA PE
K. FOOTREST SYSTEM
With the footrest system, Sunrise Medical offers either a single Flip-up Footplate (A), or dual footplates (B)
that are able to accomodate all of the possible heights and adjustment angles that the rider may require for
their comfort and support.
L. SWING-AWAY FOOTREST
The footrest system can also accomodate a swing-away hanger(C) with dual footplates (B) that are both
height adjustable and angle adjustable.
Swing-in-Swing-out Hangers and Footrests (80°)
1. Basic Footrest Installation
a. From the side, place the pivot (C) into the top of the frame tube which guides the hanger into the
correct alignment with the locking plate (D) on front frame tube.
b. Rotate the footrest towards the front of the chair until it locks into place on locking plate.
2. Removal
a. To remove footrest, release latch (E) by pulling lever upward or pushing lever downward.
b. Rotate footrest inward or outward and lift.
M. UPHOLSTERED BACKREST
1. Locking the upholstered Backrest into place
Zippie wheelchairs with depth adjustable backs are shipped with the backrest/stroller handles (F) in a folded
position. To secure backrest/stroller handles, lift backrest/stroller handles to upright position. When secured,
backrest release pin (H) will lock into place.
2. Adding or Removing upholstered Backrest
a. Check monthly for excessive stretching of the upholstery, or loose attaching hardware. If you deter-
mine the upholstery is no longer tight, contact your service representative for a replacement.
b. If you need to replace the backrest upholstery, or remove it to add a solid backrest, start by removing
the Upholstery securing screw (G) from both backrests, and pull the Upholstery off of the backposts.
21 22
22 23
24
17
VIII. USE AND MAINTENANCE
C
C
D
21
22
23
24
MK-100090 RevA