General Safety Precautions - entrematic Ditec E1A Manuel Technique

1. General safety precautions

Failure to observe the information in this manual may result
in minor personal injury or damage to equipment.
Save these instructions for future reference.
This installation manual is intended for qualified personnel only.
Installation, electrical connections and adjustments must be performed in accordance with
Good Working Methods and in compliance with applicable regulations.
Before installing the product, carefully read the instructions. Bad installation could be hazard-
ous.
The packaging materials (plastic, polystyrene, etc.) should not be discarded in the environ-
ment or left within reach of children, as these are a potential source of hazard.
Before installing the product, make sure it is in perfect condition.
Do not install the product in an explosive environment and atmosphere: gas or inflammable
fumes are a serious hazard risk. Before installing the motors, make all structural changes
relating to safety clearances and protection or segregation of all areas where there is risk of
being crushed, cut or dragged, and danger areas in general.
Make sure the existing structure is up to standard in terms of strength and stability. The motor
manufacturer is not responsible for failure to use Good Working Methods in building the frames
to be motorized or for any deformation occurring during use.
The safety devices (photocells, safety edges, emergency stops, etc.) must be installed
taking into account: applicable laws and directives, Good Working Methods, installation
premises, system operating logic and the forces developed by the motorized door.
The safety devices must protect any areas where the risk exists of being crushed, cut or gragged,
or where there are any other risks generated by the motorized door.
Apply hazard area notices required by applicable regulations.
Each installation must clearly show the identification details of the motorized door.
When necessary, connect the motorized door to a reliable earth system made in accordance
with applicable safety regulations. During installation, maintenance and repair, interrupt the
power supply before opening the lid to access the electrical parts. The protective casing of the
automation must be removed by qualified personnel only.
To handle electronic parts, wear earthed antistatic conductive bracelets. The motor
manufacturer declines all responsibility in the event of component parts being fitted that
are not compatible with the safe an correct operation.
For repairs or replacements of products only original spare parts must be used. The installer
shall provide all information relating to automatic, manual and emergency operation of the
motorized door, and provide the user with operating instructions.
1.1 Installation warning
Secure the control panel permanently. Drill a hole into the lower side of the container so as to
run the cables through it. Secure the cables, if they are accessible, by means of appropriate
gland plates (not provided by us). Keep the line and motor conductors separate (at least 8 mm)
from the control conductors at the terminal board connection points (for example, by means
of clamps). Connect the line and motor protection conductors (yellow-green) by means of the
transformer and control panel using the clamp provided. At the end of the installation to close
again the container.
26