Bushnell 119519 Mode D'emploi page 31

AA batteries. See note above about short battery life.
3. Make sure that the camera power switch is in the "On" position and
not in the "Off" or "Setup" modes.
4. Make sure that you are using a good quality SD card in your camera.
Bushnell recommends SanDisk
5. If the SD card has its write protect switch in the lock position, the
camera will not take images.
6. If you have used an SD card in another device before inserting it in
your Surveillance Cam, you might want to try formatting the card
using your PC (make sure you have backed up any important files
first, as formatting will erase all previous files). In some cases, other
devices may change the formatting of the SD card so that it will not
work properly with the Surveillance Cam.
Camera won't power up
1. Make sure that the batteries are installed correctly, observing
proper polarity. Always place the positive tip towards the "+" mark
inside the battery compartment.
Energizer
®
2. After moving the switch from "Off" to "Setup" or "On", make
sure that the switch is correctly in position to ensure the proper
mode (avoid positions "between" two modes).
3. Do not move the switch directly from "On" to "Setup"-always
move the switch all the way up to "Off" first, then back down to
"Setup".
Still Photo and/or video Quality Problems
1. Night photos or videos appear too dark
a. Check the battery indicator icon to see if battery power is full.
The flash will stop operating near the end of the battery life.
b. You will get the best results when the subject is within the
ideal flash range, no farther than 40' (12m) from the camera.
Subjects may appear too dark at greater distances.
c. Please note that when the Capture Number parameter is
set higher than "1 Photo", or with very short Interval settings,
some images may appear darker than others due to the quick
response and rapid retriggering of the camera, allowing
less time for the flash to fully recharge before firing again.
d.
Make sure "LED Control" in the setup menu is set to "High" to
ensure maximum output. You can also try setting "NV Shutter"
Lithium AA batteries in all Surveillance Cams.
SD Cards up to 32GB.
®
Bushnell recommends using 4
31