Bushnell 119519 Mode D'emploi page 16

again record an image or video once every 15 minutes between 4 and
6:30 PM. Remember, this is independent of normal triggers due to
activity–even if no humans or animals enter the IR sensor coverage
zone, an image or video will still be captured every 15 minutes during
the 2.5 hour block of time. If something triggers the camera "in
between" the 15 minute intervals, it will be recorded, same as it would
if you had setup the camera with Time Lapse turned Off. Note: Time
Lapse settings of frequent intervals and/or long periods between
start and stop time can reduce battery life.
Using the Wi-Fi Feature
Your Bushnell Surveillance Cam is capable of wirelessly transmitting
photos or videos to a nearby cell phone, tablet or computer, providing the
following requirements are all met:
• An SD card with Wi-Fi capability (such as the included 8GB Eye-Fi
Mobi card) is inserted into the card slot.
• The Surveillance Cam is connected to the compatible AC Adapter
(Bushnell #119517C, included), as Wi-Fi transmission requires a
high capacity, continuously available power supply.
• The "Wi-Fi" parameter in the Setup Menu is set to "On".
• The receiving device (smartphone, tablet, computer) is within range of
the Wi-Fi network created by the Eye-Fi card.
16
Step 1-set Time Lapse
Mode to "On"
Step 3-set Stop Time
(Hour & Minute)
Step 2-set Start Time
(Hour & Minute)
Step 4-set Interval
(60, 30, 15, 5 or 1 M)
®