Bushnell 119519 Mode D'emploi page 20

Parameter
Interval
Wi-Fi
20
Settings
(Bold=default)
10S (second)
default, with a
60M (minute)
to1S (second)
range of settings
available.
(60M-1M
are set in
one minute
increments,
59S-1S are set
in one second
increments)
Off, On
Description
Selects the length of time that the
camera will "wait" until it responds
to any additional triggers from the
PIR after a subject is first detected
and remains within the sensor's
range. During this user set "ignore
triggers" interval, the camera will
not capture photos/videos. This
prevents the card from filling up
with too many redundant images.
Settings begin with 10 second
default when parameter is first
selected. Note: after setting down
past "1S", settings start over at "60M".
Select "On" only if you are using
an SD card that includes a Wi-Fi
transmitting feature (such as
the included Eye-Fi card). Note
that you must have an internet
connection and associated Wi-Fi
network within range (adequate
signal strength) as well as a Wi-Fi
SD card to take advantage of this
feature. Also, the camera MUST
be powered by the 119517C AC
adapter (included). See pg. 17 for
more details regarding the use of
this feature.