Decalcification; Storage; Troubleshooting - BOMANN ES 184 CB Mode D'emploi

1. Remove the cover. Use the small grip. Turn slightly for easy
removal. Use a damp cloth to hold the steam nozzle with
one hand!
2. Use the spanner (18) to remove the small pipe from the
steam nozzle. See Fig. C on page 3. Turn the spanner
clockwise.
3. Leave pipe and cover for some time in the warm sudsy
water. In this way milk residue is easily removed.
4. Wipe the steam nozzle on the appliance with a damp cloth.
NOTE:
Fill a container with hot water to remove dry residue.
Place the container under the steam nozzle, so that it is
submerged.
5. After cleaning replace pipe and cover on the steam nozzle.
Place a heat-resistant empty container under the steam
nozzle. Operate the appliance as instructed under "Making
Cappuccino" points 5 and 6. After cleaning the steam
nozzle is again ready to use.

Decalcification

Scale deposits put the functionality of your appliance at risk. It
is necessary to decalcify the appliance regularly. The intervals
depend on use frequency and water hardness.
Decalcify with a commercial decalcifier for coffee machines.
1. Dose as instructed on the packaging or on the instruction
leaflet.
2. Operate the appliance as instructed for making espresso
until the tank is empty. Let the solution flow through the
group head (without filter holder).
WARNING:
• Rinse the water tank and let one full tank fresh water
flow through the group head to rinse out the decalcifier
residues.
Do not use this water for making espresso.
•

Storage

• Clean the appliance as instructed. Let the accessories dry
completely.
• We recommend that you keep the appliance in the original
packaging if the appliance will be not used for long periods.
• Always keep the appliance out of the reach of children in a
dry, well ventilated place.

Troubleshooting

Problem Possible cause
The appliance The appliance has
does not func- no power supply.
tion.
56
Problem
The appliance
does not func-
tion.
No coffee
output.
The pump is
noisy.
Espresso
escapes at the
filter holder
edge.
Solution
Test the socket with
another appliance.
Plug in the mains plug
correctly.
Check the main circuit
breaker.
Possible cause Solution
The appliance has Bleed the appliance as
not been bled before instructed under "First
first-time use. Use/Bleeding".
The appliance is Contact our service
faulty. center or a specialist.
Switch the appliance off!
The water tank is Fill the water tank with
empty. fresh water.
The water tank is not Press the tank slightly
properly attached; down for the valve to
the valve is not open.
open.
The holes in the Clean filter holder, filter
filter holder and the and group head outlet.
group head outlet
are blocked.
Air entrapped in the Generate steam as in-
heating circuit. structed under "Making
Cappuccino". Open
the steam control knob
all the way towards
" ".
The coffee grounds Loosen the coffee
are too fine or com- grounds. Spread it
pressed too much. evenly and only slightly
compress with the
tamper.
Scale deposits in the Decalcify the appliance
appliance. as instructed.
Switch the appliance off.
The water tank is Fill the water tank with
empty. fresh water.
The water tank is not Press the tank slightly
properly attached; down for the valve to
the valve is not open.
open.
Air entrapped in the Bleed the appliance as
water circuit. instructed under "First
Use/Bleeding".
Stop the brewing process!
The filter holder Attach the filter holder
is not properly properly as instructed
attached or is not under "Attach / Detach
enough closed. Filter Holder".
Too much coffee Remove excess coffee
grounds in the filter grounds. Observe the
insert. MAX marking in the
filter insert.
Coffee grounds Switch the appliance
residues on the rub- off and let it cool
down.
ber seal of the group
head.
Clean the rubber seal
as instructed.