Height Requirement; Distance Requirement; Mounting - Manitowoc iAuCS Manuel D'installation, D'utilisation Et D'entretien

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Installation Instructions

HEIGHT REQUIREMENT

Either the base or the top of the AuCS® accessory must
be within 2" (5 cm) of the base of the ice machine. Do
not mount the AuCS® unit too high or too low.
! Caution
The cleaner or sanitizer may siphon (or dispense
improperly) into the ice machine water trough if the
AuCS® unit is mounted too high or too low.

DISTANCE REQUIREMENT

The AuCS® unit must be mounted within 9 feet (2.7 m)
of the ice machine to accommodate the low voltage
communication wire and tubing. The tubing may be
shortened to accommodate a run of less than 9 feet
(2.7 m).
! Caution
Do not extend the length of the 9-foot (2.7 m) low
voltage communication wire or tubing. The correct
amount of solution will not dispense.
6
BASE OF ICE
MACHINE
2"
(5 cm)
BOX BASE OR BOX TOP
MUST BE WITHIN 2"
(5 cm) OF ICE MACHINE
BASE

MOUNTING

Parts
! Caution
The AuCS® unit may be mounted to the bin or
dispenser only when permitted by local electrical
codes.
Mounting to Bin or Dispenser
NOTE: The ice machine's serviceability may be reduced
when the AuCS® unit is mounted to the bin or dispenser.
Wall mounting is recommended.
1. Set the mounting bracket over the bin top rail at
desired location.
2. Remove the backing from the foam adhesive tape.
Apply tape to mounting bracket, and along the entire
bin rail.
3. Align the AuCS® key slots with the mounting
bracket tabs. Verify the tabs are at the top of the key
slots and that the AuCS® unit is level.
Section 2
1/2" PVC CONDUIT
FITTING
HOSE CLAMPS
LOCKNUT
BUMPER
FOAM TAPE
BRACKET
Part Number 000009036 8/13

Publicité

Chapitres

Table des Matières
loading

Table des Matières