Control Panel; Assembly - Unold 68860 Mode D'emploi

CONTROL PANEL

1 Button – Mix
2 Button Auto
3 Button – Extrude
4 Button – Cancel
5 Buttons +/-
6 Display

ASSEMBLY

1. Attention: The mains plug of the appliance must not be plugged into the electri-
cal outlet, until the appliance is completely assembled!
The appliance is equipped with a safety function. If the lid is opened in operation
2.
the appliance switches off.
3. Place the housing on a solid, level and dry surface.
4. Slide the kneading container into the housing. Ensure that the round open-
ing is pointing to the front. The square opening of the kneading container
must point upward.
5. Slide the kneader through the round opening and completely into the knead-
ing container. In this process the spiral of the kneader must point to the
front. On the rear, in the appliance interior, there is a hole; the kneader must
lock in place in this hole.
6. Slide the front cover through the screws left and right into the appliance, in
this regard the "Öffnen" (Open) button must point upward.
36
1
6
2 5
Starts the manual program
Starts the automatic program
Starts extrusion of the pasta
Cancels the selected program
Extend or shorten the kneading time
for the manual program
Copyright UNOLD AG | www.unold.de
3
5 4