shark LIFT-AWAY PRO STEAM POCKET MOP Mode D'emploi page 48

Assembling Your Steam Mop - cont'd
fig. 3
fig. 4
3
Use the lavender loop on the side of the cleaning
pocket to slide the mop head into the pocket. Then
secure the quick fasteners on the top of the pocket
to lock in place. (fig. 3)
4
Snap the mop head into the mop body by lining up
the groove on the back of the mop body with the
groove on the back of the mop head. Push until you
hear it latch into place. (fig. 4)
5
Turn the water tank cap anticlockwise and remove
from the tank. (fig. 5)
Use the filling flask and pour water into the tank. Do not
overfill. Replace the cap on the water tank. (fig. 6)
48
fig. 5
IMPORTANT: Do not use on unsealed wood or
unglazed ceramic floors. On surfaces that have been
treated with wax or some no wax floors, the sheen
may be removed by the heat and steam action. It
is always recommended to test an isolated area
of the surface to be cleaned before proceeding.
We recommend that you check the use and care
instructions from the floor manufacturer.
NOTE: To prolong the life of your Steam Mop, we
recommend using distilled water.
fig. 6