Operation; Min/Max Values For Temperature And Air Humidity; Searching For The Outdoor Sensor; Reception Test For The "Meteotime" Signal - Conrad DV216NL Notice D'emploi

12. Operation

a) Display of the temperature and humidity
The display section for the temperature and the air humidity is located approx. in the center
of the LC display.
With the button "IN/OUT", you switch between the display of the indoor temperature/humidity
(symbol "IN" on the display) and the outdoor temperature/air humidity (symbol "OUT" on the
display).
b) Min/max values for temperature and air humidity
By briefly pressing the "MEM" button (see chapter 8), you switch between the "MIN" and "MAX"
display and the present values.
Delete the saved data by pressing the button "MEM" for approx. 3 seconds.
For the min/max values, the device only shows "- - . -" until another data package is received
by the external sensor or if the values change.
c) Searching for the outdoor sensor
After changing the battery in the outdoor sensor or in case of reception disturbance, you can
search manually for the radio signal of the outdoor sensor.
For this purpose, press the button "IN/OUT" until a short signal sounds (approx. 3 seconds).
The symbol "OUT" blinks in the display section for the temperature/air humidity, the weather
station searches the outdoor sensor. This can take 2-3 minutes.

Do not move the weather station and the outdoor sensor during that time. Do
not press a button on the weather station.
d) Reception test for the "METEOTIME" signal
Because some weather information is contained in each DCF signal per second (the so-called
"METEOTIME" signal), it is very easy to perform a function test contrary to standard DCF
clocks.
Briefly press the button "TEST".
69