Assembly Instructions For Spraymaster With Powerdisc Hs; Routine Cleaning With Powerdisc Hs; Polishing - Cleanfix PowerDisc LS Mode D'emploi

Assembly instructions for Spraymaster with PowerDisc HS

 Fit the holder for the spray can to the bar (6) with the holder pointing upwards and, when viewed from the
operating side, to the left.
 Hook the spray can's tongue onto the holder, pivoting the holder back until the ball catch engages.
 Then slide the spring clip over the shaft adjustment unit (9).
 Attach the box on the right or left as desired.
 Point the universal-jointed hose in the desired direction.

Routine cleaning with PowerDisc HS

For routine cleaning, your machine is equipped with the following accessories:
Driving disc for Pads and corresponding pad.
 Fill the spray can with the desired product.
 Fit the drive plate with the desired pad.
 Start the machine.
 When you pull the Spraymaster lever a few times the cleaning agent is sprayed onto the floor. Now start
cleaning immediately until a shine is produced.
 We advise cleaning the surface in relatively small areas at a time.
The machine is ideal for cleaning with polymer dispersions. The coating's resistance to foot traffic and general
wear and tear is preserved. Streaks and marks are easier to remove.

Polishing

For polishing, equip your machine with the following accessories:
Driving disc for Pads and corresponding pad.
 Fit the drive plate with the pad.
 Then start the machine.
English | 17