Factory Programming; Sound Mode Programming - Elkron HPA701 Notice D'installation

3.1 FACTORY PROGRAMMING

Siren options are programmable through a series of cutting-wire jumpers, that can be identified with letters "A"
to "L".
Jumper Function
A, B, C, D Sound mode
E, F Sound time-out
G Input type
H Input reference
I Alarms count
L Scaffolds function

3.2 SOUND MODE PROGRAMMING

The siren is able to generate 16 different sound
modes, programmable through jumpers A, B, C
and D.
It is possible to chose the type of sound by
starting a listening "DEMO" phase (at reduced
power) of all 16 modes. In order to start the
demonstration, connect the battery (with BL and
TC not connected) and short-circuit for an instant
the "TEST" jumper: the listening sequence will be
obtained for the 16 modes (4 seconds for each
mode, 1.5-second interval between a mode and
another). Sequentially
generated sound, refer to the table below for
configuring the siren.
Example: if, when listening to the mode DEMO,
th
the 12 one has been chosen, refer to the table
in position 12 to know which jumpers must be cut
to obtain such type of sound.
Please refer to local laws in force in your
country in order to verify the complying with
indoor / outdoor installations.
Sound modes..................................................1
Sound time-out ...............................................3 minutes
Input type ........................................................Balanced
Input reference................................................Positive
Alarms count...................................................Disabled
Scaffolds function ..........................................Disabled
count the type
A B C D E F G H I L
N° A B
1
2
3
4
of
5
6
7
8
26/44 HPA701 - HPA702L - HPA702LG - HPA703XP
C D N° A
9
10
11
12
13
14
15
16
B C D