Safety Instructions - Dustcontrol S11000 Traduction Des Instructions De Service D'origine

Safety Instructions

Read the following Safety Instructions before starting this unit. Save the User Guide for future reference. Failure to comply with
the Safety Instructions voids the warranty and may result in personal injury and damage to the product. Dustcontrol is not
responsible for damage to the equipment caused by improper installation or improper operation of the equipment.
Warning
This unit is intended for professional use only.
Use only original accessories and consumables that are included in Dustcontrol's range.
WARNING
When using electrical devices, basic safety instructions must be followed to reduce the risk of fire, electric
shock or personal injury.
WARNING
If incorrect or non-OEM parts are used (especially filters, hoses and plastic bags), the machine can leak
hazardous dust which may result in personal injury.
Environmental protection
Recycle packaging and components according to local regulations. For more information, contact your nearest recycling center.
Work area environment
The space in direct connection to the unit must be kept clean. Do not store or handle flammable liquids or gases near the unit.
Overload
In the event of an alarm indication, do not restart the unit until the cause of the fault has been detected and the error rectified.
Bodily injuries
Warning for strong negative pressure! Never start the unit until it is properly connected to the piping system.
CAUTION
Never try to change electrical connections yourself. An error can be fatal!
WARNING
Protective gloves must be worn when assembling, handling and transporting the product.
Electricity
CAUTION
Never try to change electrical connections yourself. An error can be fatal!
In the absence of a lockable isolating power switch and/or safety switch for power to the frequency converter, a separate one
must be installed which is easily accessible and directly connected to the device.
Important safety precaution
Thisunit must only be used if all filters are intact and properly fitted.
Before performing any work on the unit or connected piping system, the main power supply to the unit must be disconnected and
in cases where a device has no integrated electrical cabinet, the power switch must be locked.
S11000, Art no. 99051-A 11