Safety Considerations - Dustcontrol DC 11-Module Instructions Originales

Safety Considerations

Read all instructions before the machine/installation is
commissioning.
Th e equipment must be installed and maintained proper-
ly by qualifi ed personnel who have study this instruction.
Dustcontrol does not take responsibility for defective
installation or maintenance.
Warning! When using electric machines, basic safety
precautions should always be followed to reduce the risk
of fi re, electric shock and personal injury, including the
following:
1. Important!
No hot particles nor ignition sources are allowed to
be sucked into the unit. Th e machine should not be
used for explosives, unstable or pyrophoric particles or
dust.
– WARNING Operators shall be adequately instruc-
ted on the use of these machines.
– WARNING Th is machine is for dry use only.
– CAUTION Th is machine is for indoor use only.
– CAUTION Th is machine shall be stored indoors
only.
2. Work area environment
Keep the area around the central unit clean. Do not
store or work with fl ammable liquids or gases near
the machine.
3. Overload
If there is an alarm signal it should be carefully
checked out to see that the machine is un damaged. If
there are any damaged parts these should be repaired
by a Dustcontrol authorised service centre. Always
follow the regulations pertinent to the material you
are working with. Do not use the machine for pur-
poses that it is not intended for.
4. Bodily injuries
Warning - High negative pressure
Do not start the fan without having it connected
to the duct work. Never let the suction come in
contact with parts of the body, for example a hand.
Th e pump generates a high negative pressure, severe
injury may result.
Warning - Very hot exhaust air
Exhaust air can be very hot.
5. Clamp risk
When emptying the container you normally should
put a trolley or moveable load bearing item under
the container before the eccentric lock is released. Be
aware of the clamp risk - the container can be heavy.
Also, when transporting the whole machine, espe-
cially when it is equipped with wheels, please be
careful. Th e unit is very heavy and there can be be
risk of an accident, especially on sloping surfaces.
6. Electricity
When the unit is delivered without integrated
control panel and the panel is not then located by
the unit, an isolator should be fi tted next to the unit.
Do not repair the electric components yourself, get
a qualifi ed electrician. Faults may cause injury. Th e
electrical connections may only be performed by a
certifi ed electrician. See also under section 8, 'War-
ning'.
7. Important measure
Never work with the dust extractor without fi rst
switching it off and locking the isolator.
8. Checking for damage
Check the machine regularly for damage. If there
are any damaged parts these should be repaired by a
Dustcontrol authorised service centre.
If the supply cord is damaged, it must be replaced
by the manufacturer, its service agent or similarly
qualifi ed persons in order to avoid a hazard.
9. Warning
Use only accessories and replaceable parts which are
available in the Dustcontrol catalogue. When using
non-genuine parts, especially fi lters and plastic sacks,
dust leaks could occur which may be hazardous to
health.
Th is appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a
person responsible for their safety. Children should
be supervised to ensure that they do not play with
the appliance.
Th is machine is intended for commercial use
only, for example in hotels, schools, hospitals,
factories,shops, offi ces and rental businesses.
DC 11-Module - 21 Part No 94123-B