Cleaning The Trimmer - Panasonic ER-GB44 Mode D'emploi

Trimming the downy hair
Holding the main body with the power
switch facing outside, trim by bringing
the blade in contact with the skin.
• Trimming your beard or moustache without an
attachment will trim hair length to approx. 0.5 mm.
Wet trimming
Trimming without the comb attachment
Cut your beard or downy hair with water or facial
cleanser on your face.
Wet trimming will decrease the friction, allowing a
smooth touch. Wet trimming is recommended to
trim a fuller beard to a length of 0.5 mm without an
attachment.
1
1
Remove the comb attachment.
2
2
Apply water, soap, etc. to your face.
3
3
Press the power switch to turn
on the main body.
4
4
Cut your beard slowly, moving
upward from the bottom
with the power switch facing
outside.
Notes
• Do not use any shaving creams as these may cause
a decrease in cutting performance due to scoring of
the blades.
• Make sure to rinse the main body with water and
apply the oil to the blades after wet trimming.

Cleaning the trimmer

• Clean the main body and the blade after each use.
(If not cleaned, the motion will become poor and the
sharpness will worsen.)
• Do not use thinner, benzine, alcohol or other chemicals.
Doing so may cause failure, cracking or discoloration
of the main body.
Wipe the main body only with a soft cloth slightly
dampened with tap water or soapy tap water.
• Make sure that the main body is turned off.
15