Panasonic ER-GB44 Mode D'emploi page 16

1. Remove the main body from the AC adaptor.
To remove light dirt
2. Remove the comb
attachment and turn
on the main body.
3. Run water down the
water inlet at the front
of the main body,
rinse thoroughly for
approximately 20
seconds, and then
turn off the main body.
• Rinse with water and shake up and down several
times to remove the water.
• Be careful not to hit the main body on the sink or
any other object while draining the water. Failure to
do so may cause malfunction.
16
To remove heavy dirt
2. Remove the comb
attachment and blade.
3. Clean the main body,
the blade and the
comb attachment with
running water.
4. Wipe off the water with a
towel and let it dry naturally.
• It will dry faster with the
blade removed.
5. Apply the oil to the blade
after drying.
6. Attach the blade and comb
attachment to the main body.
Cleaning with a brush
1. Remove the main body from the AC adaptor.
2. Remove the comb attachment and blade.
3. Brush off any hair trimmings
from the main body and from
around the blade.
4. Brush any hair trimmings out
from between the stationary
blade and the moving blade
while pressing down the
cleaning lever to raise the
moving blade.
5. Apply the oil to the blade.
6. Attach the blade and comb attachment to the main
body.