Zanussi ZDT 16011 FA Notice D'utilisation page 20

German
degrees
(°dH)
43 - 50
37 - 42
29 - 36
23 - 28
19 - 22
15 - 18
11 - 14
4 - 10
< 4
1) Factory position.
2) Do not use salt at this level.
Manual adjustment
1
Electronic adjustment
1. Press the on/off button to activate the appli-
ance. Make sure that the appliance is in set-
ting mode. Refer to 'SETTING AND
STARTING A PROGRAMME'.
2. Press and hold function buttons (B) and (C)
at the same time until the indicators of func-
tion buttons (A), (B) and (C) flash.
3. Press function button (A).
• The indicators of function buttons (B)
and (C) go off.
20
Water hardness
French mmol/l
degrees
(°fH)
76 - 90 7.6 - 9.0
65 - 75 6.5 - 7.5
51 - 64 5.1 - 6.4
40 - 50 4.0 - 5.0
33 - 39 3.3 - 3.9
26 - 32 2.6 - 3.2
19 - 25 1.9 - 2.5
7 - 18 0.7 - 1.8
< 7
2
Turn the water hard-
ness dial to the posi-
tion 1 or 2.
Clarke
degrees
53 - 63
46 - 52
36 - 45
28 - 35
23 - 27
18 - 22
13 - 17
5 - 12
< 0.7 < 5
• The indicator of function button (A) con-
tinues to flash.
• The acoustic signals operate, e.g. five in-
termittent acoustic signals = level 5.
• The display shows the setting of the wa-
ter softener, e.g.
4. Press function button (A) again and again
to change the setting.
5. Deactivate the appliance to confirm.
Filling the salt container
Caution! Only use dishwasher salt. Other
products can cause damage to the
appliance.
Water and salt can come out from the salt
container when you fill it. Risk of corrosion. To
prevent it, after you fill the salt container, start a
programme.
Water softener
adjustment
Manual Elec-
tronic
1) 9
2
1) 8
2
1) 7
2
1) 6
2
1) 1)
2 5
1 4
1 3
1 2
2) 2)
1 1
= level 5.
www.zanussi.com