Assembly; Use; Cleaning And Storage - Cleanmaxx PC-P001 Mode D'emploi

Masquer les pouces Voir aussi pour PC-P001:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

EN

Assembly

Plug the handle (9) into the main unit (6). It must click audibly into place.
If the extension rod (2) is to be used, plug it into the main unit (6) and then plug the
handle (9) onto the extension rod (2). Both parts must be heard to engage in one
another.
To remove the extension rod (2) or the handle (9), press the release button on the
handle (8) and pull it off. In addition, press the release button on the extension rod (7)
and pull it out of the main unit (6).
Attaching / Removing Attachments
Plug the attachment you want onto the main unit (6) so that the markings on the at-
tachment and main unit point towards each other. The attachment must be heard to
engage in place.
To remove the attachment, simply pull it off the main unit (6).

Use

CAUTION!
Keep animals, hair, jewellery, wide clothing away from rotating parts of the device. If
something does become caught in the device, switch it off immediately.
The device should only be used if it has been completely and correctly assembled!
Always switch off the device fi rst before attaching or removing attachments!
Do not use the device when it is connected to the mains adapter.
Switch the device off after each surface has been cleaned as this will considera-
bly increase the operating time on each battery charge.
1. Plug on the attachment you want (see the "Assembly" chapter).
2. Press the On / Off switch on the handle (9) to switch on the device.
3. Guide the attachment over the surface which is to be cleaned or polished.
4. To switch off the device, press the On / Off switch on the handle (9) again.
5. Clean the used attachment after use (see the "Cleaning and Storage" chapter).

Cleaning and Storage

CAUTION!
Make sure that the device is switched off before cleaning it!
Never immerse the device, the mains adapter or the mains cable in water or other
liquids.
During cleaning make sure that no liquid gets into the main unit, the handle or the
extension rod. Only the attachments may be cleaned with water.
Only reassemble the device once all of the parts are completely dry.
18

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

05991

Table des Matières