Rittal CMC III LTE Mode D'emploi page 7

4 Assembly
4.1 Assembly instructions
The LTE unit is assembled as shown in fig. 2.
5 Installation and operation
5.1 Operating and display elements
The operating and display elements are shown in fig. 3.
Key to fig. 3
1 Multi-LED for status display
2 Connection of the CMC III Processing Unit RJ 12/RS 232, 24 V
item 7)
3 SIM card chassis
4 Button for ejecting the SIM card
5 Aerial connection
6 Aerial
7 Connection of the CMC III Processing Unit RJ 12/RS 232, 24 V
item 2)
5.2 Settings
A number of SIM card settings must be made via the CMC III PU website before connecting the LTE
unit.

In the browser, enter the IP address of the CMC III PU in the network. The login dialog for logging in
to the device will be displayed.

Log in with the username admin and the password admin.

In the left-hand section of the overview window (navigation section), click on the Processing Unit
entry and in the right-hand section (configuration section), click on the Configuration tab.

In the group box Network, click on the SMS button.

In the SMS Configuration window, in the group box Service Parameters, enter the four-digit pin
number of the SIM card in the SIM-Pin field.

In the same group box, enter the provider's text service number (depending on the selected SIM
card/provider) in the Service Number field. For example, Deutsche Telekom D1: +491710760000.

In the SMS Configuration window, in the group box Known Receivers, enter the recipient's tele-
phone number with the country code in the Phone Number field.
Example for Germany: "+49..." or "+491701234567".

Click on the Save button to change your settings.
5.3 Installation

Press the button to eject the SIM card (fig. 3, item 4). The SIM card holder will be ejected from the
chassis (fig. 3, item 3).

Insert your SIM card into the holder and push the holder and SIM card fully into the chassis.

Screw the aerial into the relevant connection at the rear of the LTE unit (fig. 3, item 5).

Be sure to erect the aerial where there is an adequate signal at all times from the SIM card's network
operator. A longer connection cable for the aerial might be needed in order to achieve this.

Connect the LTE unit to the CMC III PU using an RJ 12 connection cable (fig. 3, item 2 or item 7).
Rittal CMC III LTE unit
Assembly, Installation and operation
, 500 mA (alternative to
, 500 mA (alternative to
EN
7