Rittal CMC III LTE Mode D'emploi page 8

Installation and operation, Service
Status change display on the multi-LED of the LTE unit:
– Continuous blue light: A connection is being made.
EN
– Continuous green light: The LTE unit is ready to transmit.
– Continuous orange light: A text message is being transmitted.
– Continuous red light: Initialisation error.
If installation was unsuccessful: see section 1.1.
Note:
Connection cables in various lengths can be purchased from Rittal.
5.4 Configuration
Once installation is complete, you can check the status of the LTE unit on the CMC III PU website and
configure the recipients for text messages.

In the left-hand section of the overview window (navigation section), click on the Processing Unit
entry and in the right-hand section (configuration section), click on the Observation tab.

In the configuration section, open the "System" level, followed by the sub-level "V24 Unit (V24 Port)".

Ensure that the entry "SMS Unit o.k." appears in the Message field, and the entry "OK" appears in
the Status field.

Check whether a sufficiently high signal strength is shown in the Signal field. If not, it may be neces-
sary to change the location of the aerial or use a longer connection cable.

Next, configure the recipients for text messages and set up appropriate alarms in the alarm config-
uration for status changes which will trigger the sending of text messages (see Assembly, Installation
and Operating Instructions for the CMC III Processing Unit).
For any required software updates, please visit www.rittal.com or contact Rittal Service (see section 6)
6 Service
For technical queries, please contact:
Tel.: +49 (0)2772 / 505-9052
E-mail: info@rittal.de
Homepage: www.rittal.com
For complaints or service requests, please contact:
Tel.: +49(0)2772 505-1855
E-mail: service@rittal.de
8 Rittal CMC III LTE unit