Rittal CMC III LTE Mode D'emploi page 6

EN
Notes on documentation, Safety instructions, Product description
1 Notes on documentation
This Installation and Short User's Guide is intended for experienced, trained specialists and contains
EN
only the most important information concerning the assembly, installation and function of the CMC III
LTE unit (subsequently referred to as the LTE unit).
1.1 Other applicable documents
Assembly, installation and operating instructions for the CMC III LTE unit.
These are available at www.rittal.com and contain comprehensive application-relevant information and
technical data for the LTE unit with regard to:
– Other assembly options
– Functions
– Configuration options
– Detailed operating instructions
– Troubleshooting
2 Safety instructions
– Assembly and installation of the LTE unit may only be performed by experienced, trained specialists.
– The LTE unit housing must not be opened.
– The LTE unit must not come in contact with water, aggressive or inflammable gases or vapours.
– The LTE unit may only be operated within the specified environmental conditions (see section 3.4).
3 Product description
3.1 Functional description
Text messages may be sent via the LTE unit in the event of a status change in the CMC III Processing
Unit or a connected sensor. To this end, the customer should procure a standard, commercially avail-
able SIM card.
3.2 Proper use
The CMC III LTE unit is used solely for sending text messages in the event of a status change in the
CMC III Processing Unit or a connected sensor. It must only be used together with the CMC III PU. Any
other use is not permitted.
3.3 Supply includes
– CMC III LTE unit
– Accessories supplied loose (fig. 1)
– Installation and Short User's Guide
3.4 Operating conditions
The LTE unit may only be operated under the following operating conditions:
Operating temperature range:
Humidity range:
Protection category:
6
+0 °C...+55 °C
5% to 95% relative humidity, non-condensing
IP 30 to IEC 60 529
Rittal CMC III LTE unit