Güde 40039 Traduction Du Mode D'emploi D'origine page 11

pneumatic oil to the air inlet. Then, refit the air hose and let
the impact wrench run for app. 30 seconds to allow the
compressor engine to clean out. After cleaning, follow the
lubrication instructions.
Troubleshooting
Problem Possible cause
No power Too small amount of
air (see Technical
specifications)
Impact Insufficient air pressure Check the air pressure
wrench not
working or
working
Air pressure set too
too slow
low
Impact wrench must be
lubricated with oil
Impact wrench must be
cleaned out
Air hose is leaking
EU DECLARATION OF CONFORMITY
We,
Güde GmbH & Co. KG
Birkichstrasse 6
74549 Wolpertshausen
Germany
hereby declare that the design of the appliances below
corresponds to the applicable requirements of the basic EU
safety and hygiene directives.
In case of alternation of the appliance, not agreed
upon by us, this Declaration will lose its validity.
Appliance marking
PNEUMATIC IMPACT WRENCH - SET
Art. No.
#40039
Applicable EU Directives:
2006/42/EG
Applicable harmonized standards:
EN 792-6:2000+A1:2008
Date/authorized signature: 23. March 2012
Title of signatory:
Technical documentation: J. Bürkle FBL; QS
Problem solution
Bigger compressor
on the air inlet. It must
be 6 bar.
Increase the pressure
to 6 bar
See Lubrication
See Servicing
Tighten all the hose
screwing
Managing Director,
Mr. Arnold
11