Appliance Description; Standard Delivery; Installation; Installation Site - Stiebel Eltron CNS 50 Trend Utilisation Et Installation

INSTALLATIoN

Appliance description

9. Appliance description
9.1

Standard delivery

The following are delivered with the appliance:
- Wall mounting bracket (hooked into the appliance)
10. Installation

10.1 Installation site

Installation in bathrooms
WARNING Electrocution
When installing the appliance in rooms with a bath and/
or shower, the appliance may only be connected to a
standard socket outside safety zones 0, 1 and 2. The
socket must be at least 600 mm away from a bath or
shower. If in doubt, consult a qualified contractor.
3
2
Electrical safety zones in the bathroom

10.2 Minimum clearances

≥100
www.stiebel-eltron.com
1
0
≥100 ≥500
≥20

10.3 Installing the wall mounting bracket

The appliance is intended for wall mounting using the wall mount-
ing bracket supplied. The appliance may only be installed hori-
zontally.
Note
- The wall mounting bracket can be used as a tem-
plate for wall mounting. This ensures sufficient
clearance from the floor.
- Use a spirit level if the floor is uneven or sloping.
1 2
a a a
≥224
f Unhook the wall mounting bracket from the appliance.
f Place the centred wall mounting bracket horizontally on the
floor. Mark holes 1 and 2.
f Lift up the wall mounting bracket so that its lower holes
match up with the markings you have just made on the in-
stallation wall.
f Mark holes 3 and 4 on the installation wall.
f Drill the holes at the 4 markings.
f Secure the wall mounting bracket with suitable fixing ma-
terials (screws, rawl plugs). With the vertical slots, you can
compensate for an offset fixing hole.
3
≥224
CNS Trend | CNS Trend U |
4
23