Signature STI3MG Instructions D'utilisation page 34

2. The hob will not be installed directly above a dishwasher, fridge, freezer,
washing machine or clothes dryer, as the humidity may damage the
hob electronics
3. The induction hotplate shall be installed such that better heat radiation
can be ensured to enhance its reliability.
4. The wall and induced heating zone above the table surface shall
withstand heat.
5. To avoid any damage, the sandwich layer and adhesive must be
resistant to heat.
Connecting the hob to the mains power supply
This hob must be connected to the mains power supply only by a suitably
qualified person. Before connecting the hob to the mains power supply,
check that:
1. the domestic wiring system is suitable for the power drawn by the hob.
2. the voltage corresponds to the value given in the rating plate
3. the power supply cable sections can withstand the load specified on
the rating plate. To connect the hob to the mains power supply, do not
use adapters, reducers, or branchingdevices, as they can cause
overheating and fire. The power supply cable must not touch any hot
parts and must be positioned so that its temperature will not exceed
75˚C at any point.
L1 L2
220-240
a) If the cable is damaged or to be replaced, the operation must be
carried out the by after-sale agent with dedicated tools to avoid any
accidents.
b) If the appliance is being connected directly to the mains an
omnipolar circuit-breaker must be installed with a minimum opening
of 3mm between contacts.
c) The installer must ensure that the correct electrical connection has
been made and that it is compliant with safety regulations.
d) The cable must not be bent or compressed.
N1 N2 L1
400
L2 N1 N2
220-240
220-240
- 32 -
L1 L2 N1 N2
220-240
220-240