Signature STI3MG Instructions D'utilisation page 32

Under any circumstances, make sure the Induction cooker hob is well
ventilated and the air inlet and outlet are not blocked. Ensure the
induction cooker hob is in good work state. As shown below
Note: The safety distance between the hotplate and the cupboard
above the hotplate should be at least 760 mm.
Air intake
Before you install the hob, make sure that
a) the work surface is square and level, and no structural members
interfere with space requirements
b) the work surface is made of a heat-resistant material
c) if the hob is installed above an oven, the oven has a built-in cooling
fan
d) the installation will comply with all clearance requirements and
applicable standards and regulations
e) a suitable isolating switch providing full disconnection from the mains
power supply is incorporated in the permanent wiring, mounted and
positioned to comply with the local wiring rules and regulations.
The isolating switch must be of an approved type and provide a 3 mm
air gap contact separation in all poles (or in all active [phase]
conductors if the local wiring rules allow for this variation of the
requirements)
f) the isolating switch will be easily accessible to the customer with the
hob installed
g) you consult local building authorities and by-laws if in doubt regarding
installation
mini 760 mm
mini 5 cm
Air exit
mini 5 mm
mini 2 cm
- 30 -