Sonnenkonig FRESCO 140 Mode D'emploi page 59

Timer operation
• When the air conditioner is running, press the «Timer» button to select a time between 0-24 h via the +
and - temperature buttons.
• Your selected time is shown on the display by slowly blinking.
• Confirm your time setting by pressing the «Timer» button again.
• The remaining time is now shown on the display.
• To cancel the function press the «Timer» button once and your selected time is deleted.
Swing (air flow)
• After turning on the machine, press the «Swing» (2) key and the air vents will continuously swing up and
down. When this button is pressed again, the movement will stop and the air vents will remain in that
position.
Sleep control function
• When in cooling mode, press the «Sleep» (1) key to set the temperature. It will increase by 1° C after an
hour and at most it will increase by 2° C after 2 hours.
• Press the «Sleep» (1) key again can to cancel the setting.
Drainage
• It is the alarm function if the water tank inside is filled up. The water tank in the air conditioner has a water
level safety switch which controls the water level. When the water level reaches a certain height, the "Water
full" indicator lamp will light up. (If the water pump is damaged and the water tank is full, please remove the
rubber block at the bottom of the device and all the water will drain out.
59
EN