Titan M-4 Mode D'emploi page 7

5. Loosen the fitting (5) with a wrench and pull the filter compartment (6)
and filter (7) out of the gun.
6. Insert the correct gun filter (7) into the filter compartment (6) (narrow
end of filter faces upwards).
7. Place the handle seal (8) into the gun head with the flat side of the seal
toward the gun head.
8. Insert the filter compartment (6) back into the gun and screw it securely
into place.
9. Connect a Titan original high-pressure hose of the proper pressure
rating to the material inlet on the airless gun. Using two wrenches (one
on the gun and one on the hose), tighten securely.
Before connecting to the airless spray device, check that all
parts of the gun and hose are screwed firmly and securely into
position.
Operation
1. Make sure the arrow on the tip handle is pointing in the forward
direction for spraying.
2. Start the sprayer. Refer to the instructions in the sprayer's Owner's
Manual.
3. Adjust the fluid pressure on the sprayer until the spray is completely
atomized. Always spray at the lowest pressure necessary to get the
desired results.
i
The spray tip determines the size of spray pattern and
coverage. When more coverage is needed, use a larger tip
instead of increasing fluid pressure.
4. To clear a clogged tip:
a. Rotate the tip 180º so that the arrow on the tip handle is pointing opposite
the spray direction.
b. Trigger the gun once so that the pressure can blow the clog out.
M-4/M-8 GB
8
7
Flat side of
handle seal
(toward gun head)
6
5
Bevelled side of
handle seal
(toward handle)
7